Osb is made of small and fairly rectangular shaped wood chips from small resinous trees which are bonded into a panel form with wax and synthetic resin.
Osb flat roof.
However when it is penetrated by water it takes a very long time to finally dry out compared to cdx plywood.
Especially in relation to osb or plywood use for roofs walls floors.
Ensure that the product has been duly certified by the british board of agrément bba before it is used for your project.
How to correctly install plywood or osb roof sheathing.
Osb comes in 4 by 8 foot sheets as does plywood but the manufacturing process allows the production of longer and wider ones.
When the grade stamp is covered by roofing the building inspector will not be able to confirm that the correct osb roofing panel was used.
Installed correctly allowing falls to roof using per furring.
Osb a sterling board.
Thicknesses range from 5 16 to 3 4 inch and the proper one to use.
Sheets of 7 16 inch thick with no edge support can be used in an area where the snow load is 30 pounds per square foot.
Sufficient thickness 18mml.
Impervious to any waters ingress.
Alternatively osb is created from wood chips resin and adhesive that is baked and formed into the shape of a sheet of plywood.
Avoid the errors described when installing this roof sheathing.
Osb roof panels should always be installed with the grade stamp facing into the attic and the screened surface with the nail guide lines facing up.
Types of sheathing typical types of wood used for roof sheathing are oriented strand board known as osb and plywood the most popular being osb.
The minimum osb panel size is 24 inches in any direction and each sheet end must rest on a rafter.
Osb has almost the same application and usefulness as the plywood it is made from wafers of timber rather than full sheets of veneer.
Install osb panels on aligned roof trusses ensure roof trusses are in proper alignment with no curves or uneven sections when installing osb to sheathe roofs.
Oriented strand board or osb roof sheathing is a preferred material for roofing because of its strength and low weight.
The usual recommendation is that osb 3 or osb 4 bs en 300 should be used in flat roofs.
Provide a 1 8 inch gap.
It is extremely resistant to moisture.